Maxview MXL002/TWIN Manual de instrucciones descargar pdf (Pagina 21)

Pairing Control Panel and Control Box

Every Control Panel made by Maxview contains a unique electronic identification number to

prevent interference between neighbouring Seeker satellite systems.

When the Control Panel and Control Box are not paired the Control Panel displays RF

ERROR.

To pair the Control Box and Panel together press and release the Sync Button on the front of

the Control Box. The Status LED will illuminate green. Then press Satellite UP or Down

button on the panel to synchronise.

This operation is only required during installation and after any software updates.

Cable Mode

The Control Panel and Box can also be connected through the included RJ25 cable. In this

mode no batteries are required.

Note

If a different cable to the one supplied is to be used ensure that it is an RJ25 6 Pin 6

Connector cable. RJ11 and RJ14 cables use the same connector but contain 2 and 4 wires

respectively and will not function with the Control Panel.

Press Sync

Button

Press Satellite

UP/Down Button

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Sin comentarios

Maxview MXL002/TWIN Manual de instrucciones Pagina 21