Maxview MXL002/TWIN Manual de instrucciones descargar pdf (Pagina 15)

Attach Antenna Unit to Mounting Plate

Carefully lower the antenna unit onto the Mounting Plate and re-attach the M6 Nuts and

Washers that were previously removed.

Caution

Replace Nylon locking nuts if they have been removed more than twice. The locking action

of the Nylon becomes less effective if repeatedly assembled and disassembled.

Installing cables

1. Check there are no hidden cables in the roof structure and that the hole location is

clear of obstructions both internally and externally.

2. Using a holesaw drill a 25mm – 38mm hole to pass the antenna cable and satellite

cables.

3. Clean off any burrs from the hole and clean surface.

4. Pass cables through the hole.

5. Using adhesive bond cable entry plate to the roof – note the 3 cable glands should

face the rear of the vehicle.

6. Secure cable to roof using the cable clips (supplied).

Note

To prevent trip hazards it is recommended that cables are concealed in PVCu conduit (not

supplied) where access is required to the roof of the vehicle.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Sin comentarios

Maxview MXL002/TWIN Manual de instrucciones Pagina 15